Error Vector Magnitude Formula
Contents |
Help Data Source Contact Us Developed at and hosted by The College of Information Sciences and Technology © 2007-2016 The Pennsylvania State University
Vector Magnitude This page describes EVM(Error Vector Magnitude) basics,EVM equation and mention its significance in wireless system. EVM or Error vector magnitude provides
Evm Db To Percentage Calculator
insight into quality of the modulated signal/symbol. This modulated signal originates evm calculation for broadband modulated signals when bits are mapped to symbols in a complex modulation systems such as QPSK, 16-QAM, 64-QAM etc. earned value management definition It is also referred as RCE (Relative Constellation Error). Error Vector magnitude for a symbol is described in fig.1 where P1 is the ideal constellation point and P2 is http://citeseerx.ist.psu.edu/viewdoc/download?doi=10.1.1.537.7339&rep=rep1&type=pdf the measured constellation point with some impairments. Impairments may be of different types in RF and baseband chain. It include IQ mismatch (gain, phase, DC offset), frequency offset, phase noise, AM-AM distortion, AM-PM distortion, AWGN, multipath fading (fixed, time varying), interference etc. From the figure it is imperative that M and Φ are magnitude and phase errors respectively http://www.rfwireless-world.com/Terminology/Error-Vector-Magnitude.html between two constellation points. EVM Equation Where, P1= I1+j*Q1 is the ideal/reference symbol vector P2= I2+j*Q2 is the measured symbol vector WiMAX EVM Equation: Here Error Vector Magnitude is calculated for all the frames (Nf) and all packets (Lp) in each frame and all the symbols (total data and pilots carriers in each symbol are 200) in each packet. Then it is averaged to obtain rms value of the EVM as shown in the EVM equation. EVM per subcarriers and EVM per symbols for OFDM physical layer as per fixed wimax specifications described in IEEE 802.16-2004 standard is explained in physical layer measurements page. EVM conversion EVMdB = 20*log10 (EVMrms) Download Error Vector Magnitude conversion excel sheet. EVM of QPSK constellation Higher EVMdB results in closer constellation points as shown in fig. 2b and lesser EVM(dB) results in scattered constellation points as shown in fig. 2a for QPSK constellation diagram. Fig.2 EVM constellation for two different Error Vector Magnitude values Useful links Various impairments for baseband chain MATLAB code AM-AM conversio
detected symbol location—which connects the I/Q reference-signal vector to the I/Q measured-signal vector. The following graphic shows the calculation of the EVM metric as well as a diagram showing how a single error vector is calculated. EVM is calculated from the symbol points (the instant in time when symbols are detected). The computation does not include points between symbols. Therefore Points / Symbol does not affect the value. The Syms/Errs table also shows the location of the symbol that has the largest EVMError vector magnitude (EVM): A quality metric in digital communication systems. See the EVM metric in the Error Summary Table topic in each demodulator for more information on how EVM is calculated for that modulation format.. For constellations with constant magnitude (QPSKQuadrature phase shift keying, BPSKBinary phase shift keying - A type of phase modulation using 2 distinct carrier phases to signal ones and zeros., 8PSK, etc.), the EVMs are always normalized to the constellation maximum. For constellations with multiple possible magnitudes (APSK, StarQAM, 16QAM, 32QAM, etc.), the EVMs are normalized to the EVM Normalization Reference. Shaped OQPSKOffset Quadrature Phase Shift Keying: A type of QPSK modulation that offsets the bit streams on the I and Q channels by a half bit. This reduces amplitude fluctuations and helps improve spectral efficiency. and Offset QPSK use two points-per-symbol (symbols and midpoints between symbols) to compute EVM and peak EVM due to the offset between IandQ. For Offset QPSK, when the Half Sine Filter is selected, the OQPSK reference constellation points fall on a circle with a magnitude of sqrt(2)/2, but the EVM is still expressed as a percentage of the magnitude of a QPSK symbol point (magnitude = 1). For the EDGEEnhanced Data for Global Evolution: A technology that gives GSMA and TDMA similar capacity to handle services for the third generation of mobile telephony. EDGE was developed to enable the transmission of large amounts of data at a high speed, 384 kilobits per second. (It increases available time slots and data rates over existing wireless networks.) demodulation format, the EVM, Phase, and Magnitude Error data results may vary for different Points / Symbol settings. When Points / Symbol is set to 1 (default), the trace data results are compensated for ISIInter-Symbol Interference: An interference effect where energy