Hdd Controller Failure Error Message
Contents |
steps to help prevent it. Hard drive not connected properly Verify that the cables are properly connected to the back of the hard drive. All hard drives have hard drive controller failure at least two cables connected to the back of the drive. Verify that the
Hdd Controller Failure Symptoms
power cable is connected as well as the Interface cable. Note: the interface cable must also be connected in the hard disk troubleshooting steps correct direction. Users who have IDE/EIDE hard drives, pin one (red or blue edge of the cable) points towards the power connection. Next, verify that the interface cable is properly connected to the interface
Hard Drive Troubleshooting Flowchart
card or motherboard. Note: if the cables appear to be connected properly, consider disconnecting and then reconnecting the cables to ensure they are firmly connected. Hard drive not setup properly If a new IDE or EIDE device has been connected to the computer, ensure that the jumpers are set properly. Verify that the computer hard drive is being properly detected and setup in CMOS setup. If your CMOS hard drive controller board replacement supports "Auto", it is recommended that it be used. Note: if the hard drive is not being detected by the CMOS you have one of the problems below. Bad hard drive cable If the above recommendations have been attempted and you are still encountering the same issue, the cable connecting the hard drive may be bad. Replace this cable with a known good cable. Bad hard drive If you continue to experience the same issues, the hard drive may be bad. We recommend that the drive be replaced. If the computer or hard drive is still under warranty it is recommended you contact the manufacturer of the hard drive or the computer for additional recommendations or replacement. Bad interface board or motherboard Finally, if none of the above recommendations resolve your issue, unfortunately it is likely that the interface board the hard drive connects to or the motherboard is bad. It is recommended that these components be replaced or that the computer be serviced. If the computer or the motherboard is still under warranty, it can likely be repaired or replaced. We strongly recommended that you contact the hardware manufacturer for additional information. Additional information See our hard drive definition for further i
Close × Menu Repair Guides Answers Forum Parts & Tools Store Teardowns Translate Join Log In GO iFixit Fast Order Create a Page Edit Billing Info Order History Logout Join Log In Repair Guides Answers Forum Parts & Tools Store Teardowns Translate View Edit History
Hard Drive Problems And Solutions
Hard Drive Troubleshooting Learn how to troubleshoot some common PC hard drive problems. Hard Drive
External Hard Disk Troubleshooting
Troubleshooting¶ Problems that occur when you have just installed a hard drive are almost always a simple matter of a bad or hard disk troubleshooting pdf incorrectly connected cable, incorrect jumper settings, or some similar trivial problem. If a newly installed drive isn't recognized by the system, turn off the system. Check the cables make sure that they're aligned properly and seated completely http://www.computerhope.com/issues/ch000446.htm and replace them if necessary. Make sure that the drive has power, and restart the system. Once a hard drive is configured properly and recognized by the system, it generally continues working properly until it fails. If you're fortunate, you may get some warning of impending drive failure, such as odd noises coming from the drive, dialogs warning of read or write failures, or a SMART drive failure warning when you start the system. https://www.ifixit.com/Wiki/Hard_Drive_Troubleshooting Unfortunately, hard drives often fail like light bulbs perfect one moment and dead the next. Any News Is Bad News If a hard drive shows even the slightest sign that it has problems, immediately copy the data from that drive to another hard drive or optical disc and replace that drive. Drive makers and third-party utility vendors offer software that claims to repair hard drive problems. Don't believe it. Once a drive has shown signs of impending failure, it will inevitably fail completely, and probably sooner than later. When a hard drive exhibits problems, your only goal should be to rescue your data from that drive. Don't even think about continuing to use a hard drive that has had problems, even if repair utilities swear that the drive is now in perfect condition. It isn't. Isolating the problem¶ When a functioning drive fails or begins returning read or write errors, there are many possible causes. Take the following steps to isolate the cause of the problem: 1. Before proceeding, note that a failing drive can become a failed drive at any moment. Insofar as is possible, while the drive is still functioning, copy the important files to another hard drive or an optical disc. If you succeed in copying all of the files you need, copy them again. A part
or Hard Disk Controller Problem? Page 1:Common-Sense Solutions to Hardware Headaches Page 2:Top Ten Crimes against Your Computer, 1-4 Page 3:Top Ten Crimes against Your Computer, 5-10 Page 4:Getting Good Technical Support Page 5:Secrets of the Hardware Gurus Page 6:Check http://www.tomsguide.com/us/troubleshoot-upgrade-fix,review-1091-8.html the Cables First Page 7:Power Supply Page 8:Hard Disk or Hard Disk Controller Problem? Page 9:Solving Printer Problems Page 10:Monitors Page 11:Liquids and Page Fault Errors Page 12:Slow Display Page 13:Memory Page 14:Bigger Hard Drives Hard Disk or Hard Disk Controller Problem? Before you consider replacing a dead hard drive, ask yourself the basic troubleshooting question: What has changed since the last time the hard drive system worked properly? If you have been recently working under the covers of the PC, go back in (unplug the PC and turn off the power first) and see whether you accidentally dislodged or failed to reconnect a power or data cable at the hard drive or at the controller end on the motherboard or in the bus. A diagnostic program can tell you whether hard disk troubleshooting the hard disk controller is functioning properly; it can also give information about any problems it finds on the drive itself. The utility can’t, however, give information about a dead controller or a dead hard drive. Check the BIOS Setup screen to make sure it has not become corrupted and that it properly identifies hard drives and controllers in your system. The next step is to try substituting a replacement hard drive that you know to be good in your system or testing your suspect hard drive in a properly functioning PC. Cross-Reference Other sources of hard disk problems are a damaged boot track, damaged system files, or a failure of the disk mechanism itself. Explore those possibilities in Chapter 10. Editor’s Note: Tom’s Guide has omitted the "Floppy Drives" section from Chapter 24 of "Fix Your Own PC." Previous Next Summary Common-Sense Solutions to Hardware Headaches Top Ten Crimes against Your Computer, 1-4 Top Ten Crimes against Your Computer, 5-10 Getting Good Technical Support Secrets of the Hardware Gurus Check the Cables First Power Supply Hard Disk or Hard Disk Controller Problem? Solving Printer Problems Monitors Liquids and Page Fault