Anr8302e I/o Error On Drive In Tsm
Contents |
ENCRYPTION AIX Fixes are available IBM Tivoli Storage Manager V6.2 Fix Pack 4 (6.2.4) Server Downloads anr8300e i/o error on library IBM Tivoli Storage Manager V6.3 Fix Pack 2 (6.3.2) Server Downloads the sims medieval cc IBM Tivoli Storage Manager V6.2 Fix Pack 5 (6.2.5.000) Server Downloads Subscribe You can track all
Ibm Tape Library Error Codes
active APARs for this component. APAR status Closed as program error. Error description Problem Description: When DRIVE Encryption is enabled and TSM device drivers are in use, following I/O errors may be seen in ACTLOG: ANR8302E I/O error on drive
NUMBER=22,CC=0, KEY=05, ASC=24 MAY OCCUR DURING DISMOUNT OF VOLUME AIX A fix is available IBM Tivoli Storage Manager V5.5 Fix Pack 2 (5.5.2) Server Downloads Subscribe You can track all active APARs for this component. APAR status Closed as program error. Error description During dismount of a volume, the following message may be reported in the ACTLOG: 05/07/2008 11:59:52 ANR8302E (Session: 123, Origin: STA_TEST) I/O error on drive DRV1 (/dev/rmt/4st) http://www.ibm.com/support/docview.wss?uid=swg1IC81832 with volume (OP=GETLOGSENSE, Error Number=22, CC=0, KEY=05, ASC=24, ASCQ=00, ... This issue can occur with all IBM Device Drivers including the "Mode/Log Sense subpage support" which is actually not used by TSM. The message may occur intermittently when dismounting a volume because the TSM server does not initialize an IOCTL memory structure correctly. To http://www.ibm.com/support/docview.wss?uid=swg1IC56431 be a match for this APAR, it is important that the operation code reported in the ANR8032E message indicates that TSM fails getting the log sense data from the drive (OP=GETLOGSENSE). . Though the message (ANR8302E) is an error message, in this case here this is only an informational type of message and does not have any negative impact on the data written out to tape. .. TSM Versions Affected: TSM Server Versions 5.3, 5.4 and 5.5 . Initial Impact: Low . Additional Keywords: log mode sense subpage uninitialized memory Local fix Problem summary **************************************************************** * USERS AFFECTED: All TSM servers with IBM LTO or 3592 tape * * drives. * **************************************************************** * PROBLEM DESCRIPTION: See ERROR DESCRIPTION. * **************************************************************** * RECOMMENDATION: Apply fixing level when available. This * * problem is currently projected to be fixed * * in levels 5.4.5 and 5.5.2. Note that this is * * * * subject to change at the discretion of IBM. * ************************************************
in threaded view ♦ ♦ | Report Content as Inappropriate ♦ ♦ TSM + HP Library + HP LTO Drive = I/O error on drive Administrator This http://mhvtl-a-linux-virtual-tape-library.966029.n3.nabble.com/TSM-HP-Library-HP-LTO-Drive-I-O-error-on-drive-td3327355.html post was updated on . Hi Mark, There is still pending issues with TSM and non-IBM LTO library with non-IBM LTO drives ... in The past, I could not even get that far as seen below. I have this configuration: Library: 70 CHANNEL: 3 TARGET: 00 LUN: 00 Vendor identification: HP Product identification: MSL6000 Series Product revision level: 2.00 Unit serial number: 80000070 NAA: 70:11:22:33:ab:3:00:00 Drive: 71 CHANNEL: 3 TARGET: i/o error 00 LUN: 01 Library ID: 70 Slot: 01 Vendor identification: HP Product identification: Ultrium 4-SCSI Product revision level: N11G Unit serial number: 80000071 NAA: 70:11:22:33:ab:3:00:01 Compression: factor 1 enabled 1 Drive: 72 CHANNEL: 3 TARGET: 00 LUN: 2 Library ID: 70 Slot: 2 Vendor identification: HP Product identification: Ultrium 4-SCSI Product revision level: N11G Unit serial number: 80000072 NAA: 70:11:22:33:ab:3:00:2 Compression: factor 1 enabled 1 I get this in TSM: ANR8302E i/o error on I/O error on drive DRIVE1 (/dev/tsmscsi/mt0) with volume HPS002L4 (OP=WRITE, Error Number=0, CC=305, rc = 12, KEY=40, ASC=00, ASCQ=07, SENSE=F0.00.40.00.00.00.00.58.00.00.00.00.00.07.00.00.00.00.00.00.00.00., Description=Drive failure). Refer to Appendix C in the 'Messages' manual for recommended action. ANR8792E Unrecoverable drive failures on drive DRIVE1 (/dev/tsmscsi/mt0); drive is now marked offline. ANR0515I Process 2 closed volume HPS002L4. ANR1227E BACKUP STGPOOL: Process 2 terminated - internal server error detected. ANR9999D Thread<60> issued message 1227 from: ANR9999D Thread<60> 0x00000000b8d93a outRptf ANR9999D Thread<60> 0x00000000631352 EndBackupProc ANR9999D Thread<60> 0x00000000631856 AfBackupPoolThread ANR9999D Thread<60> 0x00000000bfdf84 StartThread ANR9999D Thread<60> 0x0000380ea0673d *UNKNOWN* ANR9999D Thread<60> 0x0000380ded44bd *UNKNOWN* Attached is V3 syslog & dump_tape hp.lto.messagesdump_tape.HPS002L4I think this is an old issue with MHVTL+TSM .. some how it does not like a Library that is non IBM when using LTO type drives I believe, it may have to do with Drive Device Type being detected by TSM which is being thrown off by the Library model, vendor type ? is there a relationship ? Let me know if you need further testing. -nia nia Reply | Threaded Open this post in threaded view ♦ ♦ | Report Content as Inappropriate ♦ ♦ Re: TSM + HP Library + HP LTO Drive = I/O error on drive DRIVE Administrator FYI, Please note, above example invol