Dodge Dakota Error Code No Bus
Contents |
07:12:41 - 10/09/2016 V8 Dakotas FromMessage 944AMMODodge DakotaJOIN HERE5/13/200400:34:38 Subject: "no bus" electrical problemIP: Logged Message:I've got "no bus" showing where my odometer mileage is supposed to be, erratic gauges, no
2000 Dodge Dakota No Bus Code
stereo, no compass, and every warning light in the info center is dodge dakota no bus odometer on, including the airbag light. Is my computer going bye-bye? It seems to be running fine though. ( 4.7
No Bus Dodge Dakota 1999
L ). Help!! BeachNuttDodge DakotaJOIN HERE5/13/200406:36:37 RE: IP: Logged Message: I have no personal experience with your problem but from what I've seen in here your computer is on its way no bus dodge dakota 2002 out. Although I seem to recall others having that show up on their odometer saying their trucks wouldn't even start much less run good. Best of luck to you. ticatsDodge DakotaJOIN HERE5/13/200408:04:25 RE: IP: Logged Message:Just working through a checklist. Any of the following symptoms? Remote Keyless Entry Malfunction Interior Lights Will Not Come On Intermittent Wipers Will Not Function Chime Malfunction no bus dodge dakota 2001 Power Door Lock Malfunction Remote Radio Switch Malfunction (if equipped) 944AMMODodge DakotaJOIN HERE5/14/200403:50:30 RE: IP: Logged Message: None of those seem to be a problem. Interesting note...I pulled the positive battery cable to do some fuse checks, and when I put it back on about 20 minutes later, everything was almost ( repeat almost ) back to normal. Now only the airbag light stays on during driving, the passenger airbag "off" light wont come on when it's switched off, and the stereo seems to power up for a minute or two every now and then go completely dead. The guy I got the truck from said he recently pulled the stereo to replace it, but put it back when he decided to sell the truck. Could he have screwed something up in that process??? Thanks for the help!!!! ticatsDodge DakotaJOIN HERE5/14/200406:41:43 RE: IP: Logged Message:A good possibility. I put down that checklist because sometimes there is electromagnetic interference (e.g. from an aftermarket stereo, a hipo cb, etc.) with a certain bandwidth that will cause the Central Timer Module to malfunction. The CTM send the
start {4.7} fuel gage shows empty - but full. Truck won't start {4.7} fuel gage shows empty - but full. 10 Report Follow Asked by moron Sep 04, 2010 at 08:11 AM about the 2000 Dodge Dakota Club Cab Question type: Maintenance &
Dodge Dakota No Bus Error
Repair My odometer readingchanges to - No bu5 & the check engine lite & low fuel lites durango no bus fix come on. Any idea what the No bu5 code means ? I'm getting ready to drop the tank & change out the sensor/ pump unit. 10
What Does No Bus Mean On A 2001 Dodge Dakota
Answers 10,445 Report Dan answered 6 years ago its your crank sensor, its burned out and causing a 5 volt reference down at the pcm, and since your pcm and your BUS communication center interact with each other this is the reason http://www.dodgedakota.net/boards/v8/6191.html nothing is working because with the crank sensor shot the engine isnt able to find top dead center and bottom dead center therefore its just inhibiting the engine from starting. i hope this helps 2 out of 2 people think this is helpful. Mark helpful 10 Report moron answered 6 years ago Thanks for responding Dan. I've replaced the crank sensor - the obd reading confirmed that - unfortunately it still has the no bus reading & won't start. Any other suggestions? We're thinking possibly the https://www.cargurus.com/Cars/Discussion-t30923_ds486069 pcm ? Where is the bus comm center located . Thanks Mark helpful 10,445 Report Dan answered 6 years ago well before you replace the PCM try resetting it, simply remove you negative wire on the battery put the key in the ignition and hold it in the start position for like 15-20 seconds turn the key all the way off and reconnect every thing, if that doesnt fix the problem then replace the PCM unfourtunately haviing never done the job on a dakota i dont know where the PCM is located 3 out of 3 people think this is helpful. Mark helpful 10,445 Report Dan answered 6 years ago i also do not know the location of the bus center on the vehicle either Mark helpful 10 Report moron answered 6 years ago Ended up being the PCM - it wasn't sending the 5 volts to the crankshaft sensor unit. Found one at the junkyard for $80 & back on the road. FYI- both PCM & Bus center are on the passenger wheel well. Dan - Thanks for Your help 1 out of 1 people think this is helpful. Mark helpful 40 Report Justin answered 3 years ago would all this be the same on a dakota with a 5.9l v8 cause im having the same problems? 4 out of 4 people think this is helpful. Mark helpful 10 Report dodgenewbie answered about a year ago Me too same issues changed sensors still notta 1 out of 1 people think this is helpful.
Ram Dodge Dakota Dodge SUVs Dodge Durango Dodge Nitro Ramcharger, Trailduster & Power Wagon Jeeps Dodge Cars Dodge Avenger Dodge Caliber Dodge Challenger Dodge Charger Dodge Dart Dodge Daytona Dodge Intrepid Dodge Magnum Dodge Neon http://dodgeforum.com/forum/1st-gen-durango/284528-error-code-no-bus.html Dodge Stealth Dodge Stratus Dodge Viper Dodge Vans & CUVs Dodge Caravan Dodge Sprinter Dodge Pro Master Dodge Ram Van Dodge Journey A Blast From the Past Dodge Muscle Cars Dodge Classics K-Cars Technical Help & Information DIY - Do It Yourself Detailing Audio/Visual Electronics Wheels & Tires brought to you by Tire Rack Technical Archives Dodge Classifieds Vendor Group And Special Buys User Classifieds Gallery Members Tools Advanced no bus Search Tire Rim Calculator VIN Decoder Calendar Who's Online Marketplace Vendor Directory Become Vendor Member Marketplace New Posts How-Tos Register Log In Username Password Remember Me Forgot Password Log In Log In DodgeForum.com > Dodge SUVs > Dodge Durango > 1st Gen Durango error code no bus? Log In Log In User Name Remember Me? Password Register Forgot Password? Register FAQ Community Calendar Today's Posts Search Vendor DirectoryUsed Cars dodge dakota no Search 1st Gen Durango 1998 - 2003 Durango's Community Links Pictures & Albums Members Search Forums Show Threads Show Posts Tag Search Advanced Search Go to Page... error code no bus? Page 1 of 3 1 23 > Thread Tools Search this Thread #1 03-20-2011, 03:13 PM Ed Mason Registered User Join Date: Mar 2011 Posts: 7 error code no bus? I have a 2003 Durango, just took a dump. Won't start. As soon as ig.switch is turned on and try to start trans selector on instrument cluster switches down the line from P, R, D, 2, 1 over and over and then shows no bus error code. Tried to reset computer by disconnecting bat. Checked connectors on computer, unplugged and replugged in. Don't have a clue what to do. New member. Ed Mason View Public Profile Send a private message to Ed Mason Find all posts by Ed Mason #2 03-20-2011, 03:51 PM IndyDurango Champion Join Date: Jun 2006 Vehicle: 2000 Demon Durango SLT+ Location: Indiana Posts: 4,822 No Bus is the main PCM (computer) not being able to communicate to the system. 1) Check connections to the PCM throughly AFTER disconnecting the battery 2) Clean connections