Anr8302e I O Error
Contents |
ENCRYPTION AIX Fixes are available IBM Tivoli Storage Manager V6.2 Fix Pack 4 (6.2.4)
Anr8300e I/o Error On Library
Server Downloads IBM Tivoli Storage Manager V6.3 Fix Pack 2 (6.3.2) the sims medieval cc Server Downloads IBM Tivoli Storage Manager V6.2 Fix Pack 5 (6.2.5.000) Server Downloads Subscribe You can
Ibm Tape Library Error Codes
track all active APARs for this component. APAR status Closed as program error. Error description Problem Description: When DRIVE Encryption is enabled and TSM device drivers are in use, following I/O errors may be seen in ACTLOG: ANR8302E I/O error on drive
NUMBER=22,CC=0, KEY=05, ASC=24 MAY OCCUR DURING DISMOUNT OF VOLUME AIX A fix is available IBM Tivoli Storage Manager V5.5 Fix Pack 2 (5.5.2) Server Downloads Subscribe You can track all active APARs for this component. APAR status Closed as program error. Error description During dismount of a volume, the following message may be reported in the ACTLOG: 05/07/2008 11:59:52 ANR8302E (Session: 123, Origin: STA_TEST) I/O error on drive DRV1 http://www.ibm.com/support/docview.wss?uid=swg1IC81832 (/dev/rmt/4st) with volume (OP=GETLOGSENSE, Error Number=22, CC=0, KEY=05, ASC=24, ASCQ=00, ... This issue can occur with all IBM Device Drivers including the "Mode/Log Sense subpage support" which is actually not used by TSM. The message may occur intermittently when dismounting a volume because the TSM server does not initialize an IOCTL memory structure correctly. http://www.ibm.com/support/docview.wss?uid=swg1IC56431 To be a match for this APAR, it is important that the operation code reported in the ANR8032E message indicates that TSM fails getting the log sense data from the drive (OP=GETLOGSENSE). . Though the message (ANR8302E) is an error message, in this case here this is only an informational type of message and does not have any negative impact on the data written out to tape. .. TSM Versions Affected: TSM Server Versions 5.3, 5.4 and 5.5 . Initial Impact: Low . Additional Keywords: log mode sense subpage uninitialized memory Local fix Problem summary **************************************************************** * USERS AFFECTED: All TSM servers with IBM LTO or 3592 tape * * drives. * **************************************************************** * PROBLEM DESCRIPTION: See ERROR DESCRIPTION. * **************************************************************** * RECOMMENDATION: Apply fixing level when available. This * * problem is currently projected to be fixed * * in levels 5.4.5 and 5.5.2. Note that this is * * * * subject to change at the discretion of
Knowledge. If you receive helpful answer on this forum, please show thanks to the poster by clicking "LIKE" link for the answer that you https://adsm.org/forum/index.php?threads/anr8302e-i-o-error-on-drive-drv01.11480/ found helpful. Community Tip: Forum Rules (PLEASE CLICK HERE TO READ BEFORE POSTING) Click the link above to access ADSM.ORG Acceptable Use Policy and forum rules which should be observed when using this website. Violators may be banned from this website. This notice will disappear after you have made at least 3 posts. Please Give Thanks to Those Sharing Their Knowledge Forum Rules o error (PLEASE READ BEFORE POSTING) ANR8302E I/O error on drive DRV01 Discussion in 'TSM Server' started by bmallo, Oct 11, 2007. bmallo ADSM.ORG Member Joined: Oct 11, 2007 Messages: 4 Likes Received: 0 I am unable to write to tape via TSM, but I can successfully read/write to tape using the same drive via tapeutil and tar. This is a new install of TSM anr8302e i o and tape library/drive. Here is the error in TSM ACT Log: 10/11/07 19:41:50 ANR8302E I/O error on drive DRV01 (/dev/rmt0) with volume A00000L3 (OP=WRITE, Error Number=5, CC=0, KEY=0B, ASC=4B, more... (