Fix Error Code 1604 Mac
Contents |
not post a blank message. Please type your message and try again. Hojala1963 Level 1 (0 points) Q: cannot restore iPhone error code 1604 during ios5.1 update during upgrade to 5.1 ios I received a message stating could not be restored. An unknown error occurred (1604) iPhone 4, error 1604 itunes iOS 5.1 Posted on May 29, 2012 11:16 AM I have this question too Close Q: error 1604 mysql cannot restore iPhone error code 1604 during ios5.1 update All replies Helpful answers by ron245, ron245 May 29, 2012 11:33 AM in response to
Itunes Error 14
Hojala1963 Level 2 (285 points) May 29, 2012 11:33 AM in response to Hojala1963 Error 1604: This error is often related to USB timing. Try changing USB ports, uninstalling and reinstalling USB ports, and other available USB troubleshooting steps
The Iphone Could Not Be Restored An Unknown Error Occurred 1
(troubleshooting USB connections, device not recognized properly, computer won't recognize a FireWire or USB device). If you are using a dock, bypass it and connect directly to the white Apple USB dock connector cable. If the issue persists on a known-good computer, the device may need service. If the issue is not resolved by USB isolation troubleshooting, and another computer is not available, try these steps to resolve the issue:Connect the device to iTunes, confirm that the device is itunes error 9 in Recovery Mode. If it's not in Recovery Mode, put it into Recovery Mode.Restore and wait for error 1604.When prompted, click OK.Close and reopen iTunes while iPhone remains connected.iPhone should now be recognized in Recovery Mode again.Try to restore again.If the steps above do not resolve the issue, try restoring using a known-good USB cable, computer, and network connection. Helpful (0) Reply options Link to this post by terryromance, terryromance Feb 21, 2013 10:36 PM in response to Hojala1963 Level 1 (0 points) Feb 21, 2013 10:36 PM in response to Hojala1963 This worked for me. I think the key was that I changed the USB port as well and followed instructions.I shut the phone by pressing Home + Power. As soon as the phone shut down, I plugged out the iPhone and connected to another USB. While doing this, I also shut the iTunes.When I followed the instructions of restore afterwards, it sailed through. Successful.http://www.restore-iphone-backup.com/Thanks. Helpful (0) Reply options Link to this post by RajaRani, RajaRani Feb 21, 2013 10:57 PM in response to Hojala1963 Level 4 (1,455 points) iPhone Feb 21, 2013 10:57 PM in response to Hojala1963 You are trying to install older iOS which Apple does not permit. If you update to newest iOS 6.1.2 and still get the errorClick at the link below and then browse to error 1604http://support.apple.com/kb/TS3694#error1015 Helpful (0) Reply options Link to this post by Born Jamaican, Bor
Using iREB Posted by iPhoneHacks on Feb 22, 2011 | Comments (42) If you hit a 1604, 1603, 1602, 1601, 1600 error while trying to restore your iPhone with a custom iOS 4.2.1 firmware file created
Ipod Could Not Be Restored Error 1611
using Sn0wbreeze 2.2 for Windows or PwnageTool 4.2 for Mac then there is a way to itunes error 1601 bypass the error. iH8sn0w, developer of Sn0wbreeze has released a new version of iREB tool, which is compatible with iOS 4.2.1. iREB is error 1602 itunes a tool that will put your device into a pwned state so that you can upload custom firmware to it. iREB RC3 supports the following iOS devices: iPhone 2G, iPhone 3G, iPhone 3G[S] (old & new bootrom), iPhone 4 https://discussions.apple.com/thread/3988030?tstart=0 iPod Touch 2G (MB & MC), iPod Touch 3G, iPod Touch 4G iPad Apple TV 2 iREB is currently available only for Windows users. Before we start please note that that jailbreaking your iOS device may void its warranty and hence proceed with caution and at your own risk. You can follow these simple step-by-step guide to bypass the 1604, 1603, 1602, 1601, 1600 errors: Download the latest version of iREB from iH8sn0w Start iTunes (iREB needs iTunes http://www.iphonehacks.com/2011/02/how-to-fix-1604-1603-1602-1601-1600-error-while-restoring-custom-ios-4-2-1-ipsw-firmware-file-using-ireb.html 10 or above, it’s a good idea to use the latest version of iTunes – iTunes 10.1.2 as of now) Put your iOS device in DFU mode by following these steps: iPhone/iPad/iPod Touch Connect your iPhone/iPad/iPod Touch to your computer Turn it off Hold power and home together for 10 seconds (exactly). Release power but keep holding home until the computers beeps as a USB device is recognized A few seconds later iTunes should detect your iOS device Apple TV 2 Connect your Apple TV 2 with your Computer via microUSB Now reboot your Apple TV by holding down Menu + Down buttons together for around 6 seconds After reboot, immediately hold Menu + Play until you see the message in iTunes saying that Apple TV in recovery mode is detected Now close iTunes and launch the iREB tool that you had downloaded earlier Click on the relevant device from the iREB screen and wait for few seconds until you get a white or red screen on your iOS device Now start iTunes again and select your iOS device from the left hand side side bar While on the iTunes window, hold the Shift key and click on the ‘Restore‘ button. (This is a VERY IMPORTANT STEP as just clicking the ‘Restore’ button without the ‘Shift’ button will result in restoring your iPhone with the latest firmware, by holding down the ‘Shift’ bu
iTunes while Restoring from custom firmware on your iPhone, iPad, iPod or iPod Touch. And this make me so angry, when I get any of the iTunes Errors, like Error 1013, 1600, http://ohguideme.com/fix-itunes-errors-1013-1600-1601-1602-1603-1604/ 1601, 1602, 1603 or 1604. Well no worries, if you have encountered the http://www.redmondpie.com/fix-1604-1600-itunes-error-during-ios-4.0-custom-firmware-restore/ same errors, I have got solutions for iTunes errors mentioned above. It only requires 2 to 3 minutes to fix iTunes errors. I have listed below all the possible errors you may get when Restoring your Apple device via iTunes. These Errors can be fixed very easily and minutes and one thing itunes error more common between these errors is they have different Errors numbers like Error 1600, 1601, 1602, 1603 and so on but they represent one message " The iPhone Could not be Restored". The Errors may also tell " Device is Not Eligible for Upgrade" or "Device is Not Eligible for Restore" depending on the situation you face. Do not worry, i will guide you could not be step by step how to fix iTunes errors.iTunes Error 1013iTunes Error 1600iTunes Error 1601iTunes Error 1602iTunes Error 1603iTunes Error 1604Here i will demonstrate 3 Ways to fix iTunes Errors 1013, 1601, 1602, 1603 or 1604. Go for the one, easy and suitable for you.1. Fix iTunes Errors Using TinyUmbrellaSTEP 1. To begin fixing Restore Error, First Download TinyUmbrella [Direct Link] STEP 2. Now Launch TinyUmbrella and head over to "Advanced tab".STEP 3. Now Uncheck "Set Hosts to Cydia on Exit" option. Once it is done, close the TinyUmbrella and Launch iTunes to Restore your device normally.Related: How to Fix iTunes Error 31942. Fix iTunes Errors Using iREBThis method is also the easiest one to fix iTunes Errors like "1600 , 1601 1602, 1603 or 1604″ however if you are a Mac user then you can not use this method and additionally it also has got limitations for Windows usersas well it will not work with iPhone 4S and iPhone 5, iPod Touch 5G. If your device qualify then follow the instruction below:STEP 1. Download iREB from here [Direct Link]STEP 2. Now Launch the iREB application and select your device from the list of shown
OS X Apple Watch Google Google Services Android Reviews Wearables Web IoT Home Automation Developer Tools Deals More Apps Sprink Turn Off LCD Drive Icon Changer About Us Advertise RPon Fix 1604, 1600 Error During iOS 4 Custom Firmware Restore in Tunes By Taimur Asad | June 24th, 2010 Some of you might have noticed the annoying 1604, 1600 error when restoring to iOS 4 custom firmware in iTunes which is built using PwnageTool 4.0 or 4.01. The error in question looks something on the lines of this. The iPhone "[your iPhone]" could not be restored. An unknown error occurred. Going through the comments posted here, I found this fix posted by one of our reader which I thought I should share it with you all. I haven't tried this because I never got the error, but if you did get the error, let us know if the instructions posted below fixes the issue. The instructions, as posted by Carlos Leopoldo are as follows: Steps to fixing 1604 iPhone restore error: 1. There is no need to reinstall iTunes or whatever. Keep the same version that you have used to restore or backup previously. 2. Make sure that iPhone is disconnected from your computer and that iTunes is closed. 3. The following step of fixing 1604 iPhone restore error is Windows XP specific, if you are a Mac user, you may have to locate the folders yourselves as I am not sure: Go to folder C:\Documents and Settings\