Method Error Usr Sbin Fcppcmmap Etc Essmap
Benefits Sample reports Trial version Contact Us Topics: AIX, Storage Area Network, System AdministrationAIX fibre channel error - FCS_ERR6This error can occur if the fibre channel adapter is extremely busy. The AIX FC adapter driver is trying to map an I/O buffer for DMA access, so the FC adapter can read or write into the buffer. The DMA mapping is done by making a request to the PCI bus device driver. The PCI bus device driver is saying that it can't satisfy the request right now. There was simply too much IO at that moment, and the adapter couldn't handle them all. When the FC adapter is configured, we tell the PCI bus driver how much resource to set aside for us, and it may have gone over the limit. It is therefore recommended to increase the max_xfer_size on the fibre channel devices. It depends on the type of fibre channel adapter, but usually the possible sizes are: 0x100000, 0x200000, 0x400000, 0x800000, 0x1000000 To view the current setting type the following command: # lsattr -El fcsX -a max_xfer_size Replace the X with the fibre channel adapter number. You should get an output similar to the following: max_xfer_size 0x100000 Maximum Transfer Size True The value can be changed as follows, after which the server needs to be rebooted: # chdev -l fcsX -a max_xfer_size=0x1000000 -P Topics: AIX, SDD, Storage Area Network, System Administration↑Method error when running cfgmgrIf you see the following error when running cfgmgr: Method error (/usr/lib/methods/fcmap >> /var/adm/essmap.out): 0514-023 The specified device does not exist in the customized device configuration database. This is caused when you have ESS driver filesets installed, but no ESS (type 2105) disks in use on the system. Check the type of disks by running: # lsdev -Cc disk | grep 2105 If no type 2105 disks are found, you can uninstall any ESS driver filesets: # installp -u ibm2105.rte ibmpfe.essutil.fibre.data ibmpfe.essutil.rte Topics: AIX, EMC, Installation, PowerHA / HACMP, Storage Area Network, System Administration↑Quick setup guide for HACMPUse this procedure to quickly configure an HACMP cluster, consisting of 2 nodes and disk heartbeating. Prerequisites: Make sure you have the following in place: Have the IP addresses and host names of both nodes, and for a service IP label. Add these into the /etc/hosts files on both nodes of the new HACMP cluster. Make sure you have the HACMP software installed on both nodes. Just install
van GoogleInloggenVerborgen veldenBoekenbooks.google.nl - This IBM® Redbooks® publication describes the new IBM i Midrange External Storage solutions available for IBM POWERTM Systems POWER6TM servers with IBM i being a client of IBM Virtual I/O Server (VIOS). It introduces the VIOS virtualization concepts and IBM DS Midrange External Storage Systems architecture...https://books.google.nl/books/about/IBM_i_and_Midrange_External_Storage.html?hl=nl&id=Fb26AgAAQBAJ&utm_source=gb-gplus-shareIBM i and Midrange External StorageMijn bibliotheekHelpGeavanceerd zoeken naar boekeneBoek kopen - € 0,00Dit boek in gedrukte vorm bestellenBol.comProxis.nlselexyz.nlVan StockumZoeken http://www.aixhealthcheck.com/blog?topic=16 in een bibliotheekAlle verkopers»IBM i and Midrange External StorageHernando Bedoya, Ingo Dimmer, Jana Jamsek, Thomas Penzkofer, IBM RedbooksIBM Redbooks, 7 jul. 2009 - 456 pagina's 0 Recensieshttps://books.google.nl/books/about/IBM_i_and_Midrange_External_Storage.html?hl=nl&id=Fb26AgAAQBAJThis IBM® Redbooks® publication describes the new IBM i Midrange External Storage solutions available for IBM POWERTM Systems POWER6TM servers with IBM https://books.google.com/books?id=Fb26AgAAQBAJ&pg=PA300&lpg=PA300&dq=method+error+usr+sbin+fcppcmmap+etc+essmap&source=bl&ots=cvZKjYIm8u&sig=-7gBh0seqbbsORUbSth0TOW6sdI&hl=en&sa=X&ved=0ahUKEwjk89jbhuLPAhUk_4MKHc3FCosQ6A i being a client of IBM Virtual I/O Server (VIOS). It introduces the VIOS virtualization concepts and IBM DS Midrange External Storage Systems architecture of the supported models DS3400, DS4700, DS4800, and DS5000, discusses planning and sizing for IBM i Midrange External Storage, and provides detailed implementation procedures including IBM DS Midrange Storage Copy Services. Finally, it provides monitoring, maintenance, and troubleshooting hints for the triumvirate of IBM i, VIOS, and IBM DS Midrange External Storage.The information provided by this book will help customers, business partners, and IBM service professionals with planning and implementing IBM i Midrange External Storage solutions. Voorbeeld weergeven » Wat mensen zeggen-Een recensie schrijvenWe hebben geen recensies gevonden op de gebruikelijke plaatsen.Geselecteerde pagina'sPagina 72Pagina 33Pagina 161Pagina 144Pagina 406InhoudsopgaveChapter 1 Introduction1 Chapter 2 Midrange Storage architecture9 Chapter 3 IBM i Midrange Storage solution examples83 Chapter 4 Plannin
Favorite Rating: Unexpected Error occurs when clicking on the SUSE Products tab in the SUSE Manager webUIThis document (7015465) is provided subject to the disclaimer at the end of this document. Environment SUSE Manager method error 2.1 Situation After upgrading from SUSE Manager 1.7 to SUSE Manager 2.1 clicking on the SUSE Products tab in the SUSE Manager webUI (ie admin --> SUSE Products) returns a popup with the following error:"Unexpected error, please method error usr reload the page and check the server logs"Reloading does not resolve the issue.The /var/log/tomcat6/catalina.out log shows the following:2014-08-01 08:52:18,594 [TP-Processor1] ERROR com.redhat.rhn.manager.satellite.SystemCommandExecutor - Error encountered executing (args=[/usr/bin/sudo, /usr/sbin/mgr-ncc-sync, --refresh])2014-08-01 08:52:18,594 [TP-Processor1] ERROR com.redhat.rhn.manager.satellite.SystemCommandExecutor - Error message from process: sudo: no tty present and no askpass program specified2014-08-01 08:52:18,597 [TP-Processor1] ERROR com.redhat.rhn.frontend.action.renderers.setupwizard.ProductsRenderer - Exception while rendering products: Error while running product sync command: {/usr/bin /sudo,/usr/sbin/mgr-ncc-sync,--refresh}2014-08-01 08:52:18,598 [TP-Processor1] INFO org.directwebremoting.log.accessLog - Method execution failed: com.redhat.rhn.manager.setup.ProductSyncManagerCommandException: Error while running product sync command: {/usr/bin/sudo, /usr/sbin/mgr-ncc-sync,--refresh} at com.redhat.rhn.manager.setup.ProductSyncManager.runProductSyncCommand(ProductSyncManager.java:133) at com.redhat.rhn.manager.setup.ProductSyncManager.refreshProducts(ProductSyncManager.java:431) at com.redhat.rhn.frontend.action.renderers.setupwizard.ProductsRenderer.render(ProductsRenderer.java:55) at com.redhat.rhn.frontend.action.renderers.BaseFragmentRenderer.renderAsync(BaseFragmentRenderer.java:51) at sun.reflect.NativeMethodAccessorImpl.invoke0(Native Method) at sun.reflect.NativeMethodAccessorImpl.invoke(NativeMethodAccessorImpl.java:94) at sun.reflect.DelegatingMethodAccessorImpl.invoke(DelegatingMethodAccessorImpl.java:55) at java.lang.reflect.Method.invoke(Method.java:619) at org.directwebremoting.impl.CreatorModule$1.doFilter(CreatorModule.java:236) at org.directwebremoting.impl.CreatorModule.executeMethod(CreatorModule.java:242) at org.directwebremoting.impl.DefaultRemoter.execute(DefaultRemoter.java:358) at org.directwebremoting.impl.DefaultRemoter.execute(DefaultRemoter.java:311) at org.directwebremoting.dwrp.BaseCallHandler.handle(BaseCallHandler.java:105) at org.directwebremo