No Disc Error Dvd Player
Contents |
What Do I Need to Clean a DVD Laser Lens? How to Clean the Laser Pickup Lens on your DVD Player How to Fix a Scratch on a PlayStation CD How to Unjam a dvd player not spinning CD Player How to Get an MP3 Player to Work When It Is Dead
Dvd Player In Tv Says No Disc
How to Fix a Philips CD Changer You've popped the popcorn, poured a glass of your favorite beverage and settled in no disc error cd player to watch a movie, but when you press "Play" on the remote control, the dreaded "NO DISC" error appears on your DVD player. If you're lucky, you may be able to correct the problem by dvd laser lens cleaning disc just opening and closing the disc tray on the player and trying again. If you're really unlucky, your DVD player might be defective. However, more often than not, a scratched or smudged disc or a dirty laser lens in the player is usually the cause of the error, and is something you may be able to fix in a few minutes. Correcting Common Disc Problems Press the "Eject" or "Open" button
Lg Dvd Player Disc Error Message
on the DVD player to disc tray to determine if it opens easily and does not appear jammed or hindered. If the disc tray appears to open slower than usual or fails to open, the disc may not sit flush in the tray or otherwise be seated properly. Use your hand to pull out the disc tray slowly if it does not open on its own and then reseat the disc. Close the disc tray and press "Play" on the DVD player again to see if reseating the disc in the tray corrects the "NO DISC" error. Power off the DVD player, then back on again. Attempt to play the DVD disc normally. Sometimes, an error in the DVD player firmware may prevent the device from reading discs properly. When this occurs, resetting the player often corrects "NO Disc" errors. Remove the disc from the DVD player. Use a lint-free cloth and some denatured alcohol or water to clean the disc and remove any dust or smudges that may prevent the player from reading it properly. Reinsert the disc into the player and press "Play" to see if cleaning the disc fixes the "NO DISC" error. Cleaning the DVD Laser Lens Power off the DVD player and disconnect all cables
message referring to no disc being in the system. This can be infuriating because you can see that there is a disc, however, the CD / DVD player cannot. Every time the tray closes, the laser philips portable dvd player says no disc beam fires two long bursts of laser light, and the focusing platform moves up and down attempting to dvd player wont read any disc focus the beam. This is the time when it is looking for a disc. If the laser has failed, then it will not be able to
Portable Dvd Player Not Reading Disc
detect a CD and therefore the error message appears. I normally do two things when this happens. I normally clean the lens just in case there is dust on it obstructing the laser path. If cleaning the lens does not solve the problem then http://techin.oureverydaylife.com/fix-nodisc-error-dvd-player-1786.html I make sure the laser is working. Obviously one should never look directly into the laser unit, you would have to be plain stupid if you did that. The laser light is bright enough that one can see the diffused red light from a distance obliquely. A piece of paper the size of a standard CD within the tray can also help, because when the tray closes, one can see the diffused red light on the paper. It is usually bright enough and visible from the other http://www.petervis.com/CD_and_DVD_Players/no-disc-in-cd-player-error/no-disc-in-cd-player-error.html side of the paper. If there is no red light, then the laser has failed. Back in the 1990s, I used to fix many of these and it was always either the spindle motor or the laser that failed. These two components are in constant use and wear out the most. Laser diodes do not last forever, especially on the early players manufactured in the 1980s. It would be very surprising to find a player still working from that era. Most of those units used cheap motors where the brushes wore out within a few years. Moreover, if that did not fail, then the laser surely would. The laser diode manufacturing process was not as refined either, and those diodes had a short finite life to them. Most of those early CD players would be hard to find as they often ended up in landfill. I have come across many high-end players of recent time that use the same cheap mass produced drive mechanisms. Moreover, most of those failed within a few years as well. This is a shame, as one would expect high-end players to have better components for the mechanism; however, it is usually the same cheap mechanism found in unbranded supermarket models. A laser diode, being a semiconductor, fails in an interesting way. When it is reaching the end of its useful life, and about to fail, it becomes, unstable. Its operation becomes sporadic, which can confuse the user. It might work one minute, but not work the next. Alternatively, it might work for some CDs and
ProductsHomearound the homeentertainmentHow to Fix a "No Disc Error" on a Philips DVD PlayerHow to Fix a "No Disc Error" on a Philips DVD PlayerBy Greyson FergusonThe popular electronics company Philips produces a wide range of electronic products, including several makes of DVD player. While these DVD players range in size and price, most rarely run into playback https://www.techwalla.com/articles/how-to-fix-a-no-disc-error-on-a-philips-dvd-player issues. However, you may see a "No Disc Error" appear on the television screen or on the small LCD screen at the front of the DVD player, even after a disc is inserted into the drive. Typically the issue is related to the disc itself and is correctable through a few troubleshooting steps.Things You'll NeedDamp clothStep 1Press the "Open Tray" button on the front of the Philips DVD player. dvd player Look to make sure the disc is correctly placed on the disc tray. If the disc is off center the DVD player cannot read the content and will produce the "No Disc Error."Step 2Check the disc to make sure the data side of the disc is facing down (the label facing up). If the disc is inserted upside down the Philips DVD player states the error message.Step 3Remove the no disc error disc from the DVD player. Some Philips DVD players do not read self created DVDs (this varies from what model and model year you are using). Insert a standard movie DVD purchased from the store and insert it into the disc tray. The movie loads without any issue.Step 4Clean off the bottom of the DVD with a damp cloth to remove any dirt, debris or fingerprints from the disc. If the Philips DVD player is unable to read the disc it displays the "No Disc Error" message. Allow the DVD to dry before inserting it back into the disc tray.References & ResourcesPhilips: DVD Player InformationPhilips: User Manual DVD Player User ManualRelated15 Killer Ways to Spook Up Your Porch for HalloweenSmart HomeHappy Haunted Halloween TechEntertainmentWhich Streaming Device Is Family Friendliest?EntertainmentHow to Get Free Wi-Fi Access AnywhereEntertainmentStreaming Service Caters to the CuriousEntertainmentHOW WE SCOREABOUT USCONTACT USTERMS OF USEPRIVACY POLICY©2016 Demand Media, Inc.Login | Sign UpSign UpLog InCreate an account and join the conversation!Or Forgot Password? Remember meLog InCancelBy signing up or using the Techwalla services you agree to the Techwalla Terms of Use and Privacy PolicySign UpLog InCreate an account and join the conversation! Get news about the products and tech you really care