Panasonic Dvd Player No Disk Error
Contents |
message referring to no disc being in the system. This can be infuriating because you can see that there is a disc, however, the CD / DVD player cannot. Every time the tray closes, dvd player says no disc when there is one the laser beam fires two long bursts of laser light, and the focusing platform moves up and dvd player not spinning down attempting to focus the beam. This is the time when it is looking for a disc. If the laser has failed, then it will not lg dvd player disc error message be able to detect a CD and therefore the error message appears. I normally do two things when this happens. I normally clean the lens just in case there is dust on it obstructing the laser path. If cleaning the lens does not dvd laser lens cleaning disc solve the problem then I make sure the laser is working. Obviously one should never look directly into the laser unit, you would have to be plain stupid if you did that. The laser light is bright enough that one can see the diffused red light from a distance obliquely. A piece of paper the size of a standard CD within the tray can also help, because when the tray closes, one can see the diffused red light on the paper. It is usually bright
Dvd Player In Tv Says No Disc
enough and visible from the other side of the paper. If there is no red light, then the laser has failed. Back in the 1990s, I used to fix many of these and it was always either the spindle motor or the laser that failed. These two components are in constant use and wear out the most. Laser diodes do not last forever, especially on the early players manufactured in the 1980s. It would be very surprising to find a player still working from that era. Most of those units used cheap motors where the brushes wore out within a few years. Moreover, if that did not fail, then the laser surely would. The laser diode manufacturing process was not as refined either, and those diodes had a short finite life to them. Most of those early CD players would be hard to find as they often ended up in landfill. I have come across many high-end players of recent time that use the same cheap mass produced drive mechanisms. Moreover, most of those failed within a few years as well. This is a shame, as one would expect high-end players to have better components for the mechanism; however, it is usually the same cheap mechanism found in unbranded supermarket models. A laser diode, being a semiconductor, fails in an interesting way. When it is reaching the end of its useful life, and about to fail, it becomes, unstable. Its operation becomes sporadic, which can confuse the user. It might work one minute, but not
What Do I Need to Clean a DVD Laser Lens? How to Clean the Laser Pickup Lens on your DVD Player How to Fix a Scratch on a PlayStation CD How to Unjam a CD Player How to Get an MP3 Player to Work When It Is Dead How to Fix
Philips Portable Dvd Player Says No Disc
a Philips CD Changer You've popped the popcorn, poured a glass of your favorite beverage and settled how to fix a cd player that says no disc in to watch a movie, but when you press "Play" on the remote control, the dreaded "NO DISC" error appears on your DVD player. If you're lucky, portable dvd player not reading disc you may be able to correct the problem by just opening and closing the disc tray on the player and trying again. If you're really unlucky, your DVD player might be defective. However, more often than not, a scratched or smudged disc or http://www.petervis.com/CD_and_DVD_Players/no-disc-in-cd-player-error/no-disc-in-cd-player-error.html a dirty laser lens in the player is usually the cause of the error, and is something you may be able to fix in a few minutes. Correcting Common Disc Problems Press the "Eject" or "Open" button on the DVD player to disc tray to determine if it opens easily and does not appear jammed or hindered. If the disc tray appears to open slower than usual or fails to open, the disc may not sit flush in the tray or otherwise be seated properly. Use your hand http://techin.oureverydaylife.com/fix-nodisc-error-dvd-player-1786.html to pull out the disc tray slowly if it does not open on its own and then reseat the disc. Close the disc tray and press "Play" on the DVD player again to see if reseating the disc in the tray corrects the "NO DISC" error. Power off the DVD player, then back on again. Attempt to play the DVD disc normally. Sometimes, an error in the DVD player firmware may prevent the device from reading discs properly. When this occurs, resetting the player often corrects "NO Disc" errors. Remove the disc from the DVD player. Use a lint-free cloth and some denatured alcohol or water to clean the disc and remove any dust or smudges that may prevent the player from reading it properly. Reinsert the disc into the player and press "Play" to see if cleaning the disc fixes the "NO DISC" error. Cleaning the DVD Laser Lens Power off the DVD player and disconnect all cables. Use your fingers to open the disc tray door slowly and gently. Alternatively, insert a pin or straightened paper clip into the small "Manual Eject" hole next to the disc tray if the unit has one. Use a can of compressed air to blow out the inner area of the DVD player exposed by opening the disc tray. Use short bursts of air from the can to clean out any dust or residue that may be covering the laser lens and preventing the player from reading discs. Allow any moisture created by the canned air to dry a few minutes before continuing. Rec
Error on a DVD Player How to Fix a No-Disc Error on a DVD Player By eHow Electronics Editor eHow Contributor eHow Electronics Editor Follow Pin Share Tweet Share Email Save Tired of http://www.ehow.com/how_2036277_fix-error-dvd.html seeing the no-disc error every time you try to watch a movie? No-disc errors are usually caused when the DVD or the laser-lens pickup has become dirty and causes the DVD player to not be able to read the DVD. Follow these steps to find out how to fix a no-disc error on a DVD player. Other People Are Reading How to Clean the Laser Pickup Lens on your DVD Player How to dvd player Clean DVD Heads Things You'll Need Isopropyl alcohol Lens cleaning disc Check the disc you're using for scratches and dirt. If the disc is damaged it won't play properly, regardless of the DVD player's ability to function. You can use a DVD repair device like the "Disc Doctor" to repair the DVD or purchase a new DVD. Make sure the discs you're using fit the correct format specified by your DVD player. For example, says no disc if your DVD player doesn't support home-burned DVD-R's, then you can't use a DVD that you made at home. You may need to upgrade to a newer model, most of which accept the latest DVD formats. Clean the laser lens with a DVD laser lens cleaning disc. DVD laser lens cleaning discs can be purchased at most electronics retailers or online. Insert the laser lens cleaning disc and follow the instructions. Insert a correctly-formatted, undamaged disc into your player. Listen to see if it begins to read the disc. If it continues to make no sound and gives you the same message, then the problem is probably that your disc is not spinning in the device. Turn the device off and unplug it. Take off the outer casing by removing the three or four screws and lifting the top piece off. This will allow you to see if anything is simply stuck or jammed. If this is the case, a simple nudge back to the correct position will fix the problem. Clean the lens while the DVD player is open. A dirty lens is most likely the cause of your no-disc error. The lens should be cleaned with isopropyl alcohol and a cotton swab. Take your DVD player to have it professionally fixed only when none of these other s