Hp 4100 Printer Error Codes
Contents |
2. Printing from tray 1 is fine and a tray from a 4050 seems OK. I have replaced the feed and seperation rollers and the fuser (which was noisy). If I pull the tray out a little it will print OK but I can see nothing wrong with the tray and I can hear all three microswitches click when the tray is pushed in (A4 paper). Can anyone help? Respond to this 0 You may want to observe the paper movement from the back of the printer. When a sheet starts to print it moves about 1/3 forward, stops for http://h20564.www2.hp.com/portal/site/hpsc/public/psi/troubleshootResults?sp4ts.oid=83239 a momemt and then prints when the dc controller starts its actions. If the paper moves forward and then comes back a bit, the problem is with the clutch in the tray. Your tip off should be that another tray works ok. If that is the case it is something in the tray. You can try to run the tray without the clutch to see if that is the problem. Good Luck. By http://www.fixyourownprinter.com/posts/15471 the way if it is the older style clutch (the 4100 had two types) it can be cleaned. Let us know and I will give you instructions. by dmzcompute on Jan 9, 2004 at 11:29pm Add comment Please sign in to comment Hi dmzcompute,You've helped me in the past, hope you can help me now. I have a LJ4100 (tray 2 only) that will print any 2+ page print job and at the end of that job, send a blank page through that will stop just as the leading edge goes through the fuser. It then registers a 13.6 error. There is also one page picked up by tray 2 that has not made it through the paper feed assembly. I remove the page at the fuser, let the machine reset. The printer then spits out the page that was at the paper tray and comes back to the ready state. When I watched th paper load from the back, I did not see the paper move back & forth. It was smooth movement. I tore the printer apart and could not find anything out of the ordinary. It does the same after I put it back together. I also tried a different fuser, so it can't be the fuser or fuser sensors, correct? Is it a possibi
Printer Error Codes and Support Error: DISK DEVICE FAILURE 13.0 PAPER JAM DISK FILE OPERATION FAILED 13.1 PAPER JAM OPEN INPUT TRAYS DISK https://www.orionmarket.com/product_error_page/HP/HP-4100/ FILE SYSTEM IS FULL 13.10 PAPER JAM CHECK DUPLEXER DISK IS WRITE PROTECTED 13.2 PAPER JAM OPEN INPUT TRAYS DUPLEX ERROR CHECK DUPLEXER 13.20 PAPER JAM CHECK REAR DOOR EIO https://www.marketpoint.com/hp-printer-error-codes.aspx [x] INITIALIZING 13.21 DOOR OPEN JAM EIO [x] NOTFUNCTIONAL 13.5 PAPER JAM CHECK REAR DOOR ENV FEEDER LOAD[TYPE] [SIZE] 13.6 PAPER JAM CHECK REAR DOOR ENVELOPE FEEDER SIZE = [xxxxx] hp laserjet 13.99 PAPER JAM [LOCATION] ENVELOPE FEEDER TYPE = [xxxxx] 13.XX PAPER JAM[LOCATION] FLASH DEVICE FAILURE 20 INSUFFICIENT MEMORY FLASH FILE OPERATION FAILED 21 PAGE TOO COMPLEX FLASH FILE SYSTEMIS FULL 40 EIO x BAD TRANSMISSION FLASH IS WRITE PROTECTED 41.3 UNEXPECTED PAPER SIZE INPUT DEVICE CONDITION [XX.YY] 41.5 PRINTER ERROR INSTALL DUPLEXER 41.x PRINTER ERROR INSTALL TONER CARTRIDGE 49.XX PRINTER ERROR hp laserjet 4100 INSTALL TRAY [X] 50.4 PRINTER ERROR LOADING PROGRAM 50.X FUSER ERROR MANUALLY FEED [TYPE] [SIZE] 51.X PRINTER ERROR MEMORY FULL STORED DATA LOST 52.X PRINTER ERROR MEMORY SETTINGS CHANGED 53.XY.ZZ PRINTER ERROR MEMORY SHORTAGE JOB CLEARED 54.1 REMOVE SEALING TAPE MEMORY SHORTAGE PAGE SIMPLIFIED 54.4 PRINTER ERROR NON HP TONER DETECTED 55.xx PRINTER ERROR OFFLINE 56.X PRINTER ERROR OUTPUT BIN FULL 57.X PRINTER ERROR PAPER WRAPPED AROUND FUSER 58.2 PRINTER ERROR PERFORM PRINTER MAINTENANCE 59.X PRINTER ERROR PROCESSING CLEANING PAGE 62.X PRINTER ERROR PROCESSING JOB 64 PRINTER Error RAM DISK DEVICE FAILURE 66.XX.YY Error RAM DISK FILE SYSTEM IS FULL 68 NVRAM ERROR CHECK SETTINGS RAM DISK FILEOPERATION FAILED 68 NVRAM FULL CHECK SETTINGS RAM DISK IS WRITE PROTECTED 68.X PERMANENT STORAGE TONER LOW 68.X PERMANENTSTORAGE FULL TONER OUT 69.X PRINTER ERROR TRAY [X] EMPTY[TYPE] [SIZE] 79 SERVICE [XXXX] TRAY [x] LOAD [TYPE][SIZE] 8X.YYYY EIO [Z] ERROR TRAY 1 LOAD [TYPE] [SIZE] ACCESS DENIED MENUS LOCKED TRAY 1 SIZE = [xxxx] BAD DUPLEXER CONNECTION TRAY 1 TYPE = [xxxx] BAD ENV FEEDER CONNECTION UNABLE TO MOPY JOB BAD OPT TRAY
brands HP Models Lexmark Models Xerox Models Model : Choose a brand Type : Choose a model My Account I Require An Access Code Technical Resources Maintenance Kits Fusers Toner Rollers & Pads Printers Search All Maintenance Kits Fusers Toner Rollers & Pads Printers Search All Troubleshooting HP Printer Issues and Error Codes The following technical information is provided to help you with general troubleshooting of HP printers and to help resolve HP printer errors. We stock the full range of HP printer service parts needed for preventive maintenance and repair service. If you have other tech support questions that are not covered here, send email to techsupport@marketpoint.com. Begin by selecting the printer model below or click here for general troubleshooting help. Mono LaserJets: 4000, 4050, 4100, 4200, 4240, 4250, 4300, 4350, 5si, 8000, 8100, 8150, 9000/9040/9050, P3005/3015, P4014, P4015, P4515 Color LaserJets: 3000, 3500/3550/3700, 3600, 3800, 4600, 4610, 4650, 4700, 5000, 5100, 5500, CP3005, CP3015, CP3505 MultiFunction Printers: CM1312, CM232, CM3530, M500, M575, M6XX, M1536, M2727, M35xx, M5025/M5035 HP Color LaserJet 3000, 3600, 3800 and CP3505 10.92 Cartridge Not Engaged Error HP Color LaserJet 3500, 3550, 3700 Toner Specks Running Down the Page HP LaserJet P3005/P3015 Models Intermittent Jamming or Black Marks on Back of Page Broken Paper Trays and Feed Issues 49 Formatter Error Noise in Printer HP Color LaserJet 4000, 4050 and 4100 Model Series Groaning-typeNoise 13.1 Paper Jam Error 13.20 Paper Jam Error 41.3 Tray 1 Load Letter Error 41.5 Media Feed Error 49.xxxx Service Errors 57.01 Fan Error Control Panel Buttons Troubleshooting Multiple Feeding from the Manual Paper Tray Troubleshooting Noises & Squeaks HP Color LaserJet 4200, 4240, 4250, 4300, and 4350 Model Series 13.01 Paper Jam Error 13.20 Paper Jam Error 60.2 Tray 2 Lift Error 68.xxxx Permanent Storage Error Network/JetDirect Card Problems Clearing the RFU Error Message Blank Displa