Hp Laserjet 6p Error Light
Contents |
out couldn't tell me any specifics other than it just "quit working". I know that sometimes when the lights flash on printers, you can hp laserjet 6p driver reset those "maintenance requests", and the printer will work again. Of course, you should also hp laserjet 6p toner replace the part too if possible and correct the reason the error came up. Anyway, when I turn it on, the amber hp laserjet 6mp colored error light is the only light lit. I know the other lights are working because the initially flash on when the printer starts. The printer does not try to pick up any paper from either
Hp Laserjet 6p Specs
tray. However, the gears toward the back of the printer will spin briefly. Supposedly this is a recoverable error so I have checked that the top is closed, toner is in place, and that there are no paper jams. Paper sensor at front and near exit roller also seem to be in working order.I removed the black plate held in place by one screw that is under the toner cartridge. No paper hp laserjet 6p manual there either.I have also held down the cancel button (button closed to the back of the printer and above the error LED) while turning the printer on. All the lights will light up. I continued to hold the cancel button for over a minute to hopefully "erase" anything if this was some type of maintenance request that needed to be cleared. Any other suggestions as to what may be wrong? By any chance could it be a bad toner cartridge? How likely would that be? Even so it is still in place so the printer should sense that the cartridge is at least in place. Also, can someone tell me how to do the engine test? Perhaps I misunderstood what I read and saw. I've seen a diagram that seems to suggest it's inside the formatter (same side as panel buttons), and one had to remove the seven screws with an Allen wrench to get to it. The first problem is that I could only remove three of them. The others won't budge. Also, is there a button? Do you stick something in that hole? I couldn't see anything where the diagram said it's supposed to be. If it is behind this formatter, is there any way I can get to it without removing that format
Handling Unprintable Regions: .14 inch all sides Loading Paper into Tray 2 Slide Tray 2 (paper cassette) out of the printer. Load paper up to the arrows on the paper length spacer in the rear of the tray (approximately 250 sheets). Make sure the paper is flat in hp laserjet 6p troubleshooting the tray at all four corners. If needed, press on the clip lever (A) to raise the front
Hp Laserjet 6p Windows 10
left metal holder (B) so the paper will fit underneath. Align the slots (C) on the sides of Tray 2 with the rails (D) inside the
Hp Laserjet 6p Service Manual
Tray 2 cavity. Slide Tray 2 completely back into the printer. Note: Tray 2 is designed for paper use only. Use Tray 1 to print envelopes, labels, transparencies, cardstock or custom-sized media. Loading Media into Tray 1 Tray 1 (multi-purpose) holds up to 100 http://www.fixyourownprinter.com/posts/45209 sheets of paper or up to 10 envelopes. Grasp Tray 1 by the two finger tabs and pull the top down. Pull out the plastic tray extender by grasping the center finger tab. If the media being loaded is longer than 9 inches (229 mm), also pull out the wire tray extender. Slide the paper width guide to the far right side of the tray. Place media into the tray (short-edge in, print-side up). The media should be flush left, under the tab on the left paper guide. Slide https://www2.nefec.org/upm/printers/mhpl6p.htm the paper width guide to the left until it lightly touches the media without bending it. Make sure the media fits under the tab on the paper width guide. Note: Do not add media to Tray 1 while the printer is printing. This could cause a paper jam. Changing Paper Size in Tray 2 Pull Tray 2 straight out of the printer and remove any paper. Press the top of the green paper width guide toward the center of the tray. The guide should detach from the tray. Align the pointer on the end of the guide with the desired paper size. Insert the two left side tabs into the appropriate holes (A) and push back on the guide to the upright position (B), snapping the center tab into place. For A4, Letter, Executive and B5 paper sizes, skip to step 7. For legal paper size, continue with steps 5 and 6. Locate the green subtray at the back of Tray 2. Grasp the front corners of the subtray and pull straight up to remove. Move the subtray to the rear position (C), aligning the tabs on the front sides of the subtray with the rear grooves. Press the subtray down until it snaps into place (D). Press the top of the paper length guide toward the center of the tray. The guide should detach from the tray. Align the pointer on the left of the guide (E) with the desired paper size. Insert the two front side tabs into the appropriate holes (F) and push back on the guide to the up
62................................................................................................................................................................ troubleshooting ir printing problemspage 127................................................................................................................................................................ Print This PagePrint ShareShare Url of this page: HTML Link: Bookmark Manuals Brands HP Manuals Printer LaserJet 6P Service manual HP https://www.manualslib.com/manual/464737/Hp-Laserjet-6p.html?page=116 LaserJet 6P Service Manual: Status Panel Lights Hide thumbs Also See for LaserJet 6P Service supplement manual - 117 pages 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 hp laserjet 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 hp laserjet 6p 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 114 115 116 117 118 119 120 121 122 123 124 125 126 127 128 129 130 131 132 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 148 149 150 151 152 153 154 155 156 157 158 159 160 161 162 163 164 165 166 167 168 169 170 171 172 173 174 175 176 177 178 179 180 181 182 183 184 185 186 187 188 189 190 191 192 193 194 195 196 197 198 199 200 201 202 203 204 205 206 207 208 209 210 211 212 213 214 HP LaserJet 5P/5MP, 6P/6MP Printer Service Supplement New Product Features Status Panel Lights There are six Status Panel lights on the printer: ERROR DATA READY These lights indicate the current status of the printer by displaying an amber or a green hue and flashing individually or sequentially as a gro
be down. Please try the request again. Your cache administrator is webmaster. Generated Mon, 17 Oct 2016 23:29:35 GMT by s_ac15 (squid/3.5.20)