Hamilton Controller Error Codes
Contents |
DISTRIBUTORS Locate a
Hamilton Validator Repair
Distributor Locate a Service Center CONTACT Return to Content hamilton bill validator Support What can we help you with today? FAQ's Browse the most
Hamilton Xe Validator For Sale
frequently asked questions CREDIT CARD SETUP Setup information & welcome packets TECH SUPPORT Contact our technical support team ON SITE TRAINING Learn about what our on hamilton c2000 controller for sale site training offers REQUEST AN RA NUMBER Need to return a part? Start the process here. SERVICE CENTERS Locate a Hamilton-certified service center CONTACT 1026 Hamilton Dr. Holland, OH 43528 P: (888) 723-4858 P: (419) 867-4858 F: (419) 867-4850 E: sales@hamiltonmfg.com NEWSLETTER SIGNUP QUICK LINKSHome About Us All Products Parts Downloads Support Distributors Contact © 2016 Hamilton Manufacturing Corp. All Rights Reserved. 1026 Hamilton Drive, Holland OH 43528 Participating Organization WordPress Download Manager - Best Download Management Plugin Close
the validator. The sticker has the serial number, model, version, and date of manufacture of your validator. In case the
Hamilton Changer Controller
eprom has been changed in the validator and the sticker wasn’t updated, on an XE validator; with the power ON, turn all of the dip switches to the OFF position, then turn ON switches (in this order) 9 and 1. The display will flash 3 numbers; this is the version installed in the validator. My validator rejects too many bills, how http://www.hamiltonmfg.com/support/ can I improve the acceptance rate? Setting up a regular maintenance schedule is recommended. Depending on use, the validator should be cleaned and calibrated every 2-4 months. What should I use to clean my validator? Use rubbing alcohol and cotton balls or Q-tips. How often should I clean my validator? Depending on use, the validator should be cleaned every 2-4 http://www.hamiltonservices.org/Documents/shopframes/faq.php months. How do I clean my validator? ** Always turn the power OFF when disconnecting and reconnecting the validator ** The XE series: There are (2) nickel-sized latch studs on the validator, (1) on each side. Loosen those screws and the bill path will hinge open. Using rubbing alcohol and cotton balls/Q-tips, clean the entire bill path, including the (2) silver heads, white nylon rollers, and the sensors. DO NOT CLEAN THE BELTS!! After cleaning, close the bill path and tighten the latch studs back up. (XE 101-0079 page 9) STA series: There are (2) slides on the validator, (1) on each side, sliding those back together the bill path will hinge open. Using rubbing alcohol and cotton balls/Q-tips, clean the entire bill path, including the (2) silver heads, white nylon rollers, belts, and the sensors. It’s ok to clean the belts on the STA validator. After cleaning, close the bill path, making sure the slides lock back into place (you will hear them snap when locked in place). How do I calibrate my validator? XE validator (2132) STA (2131)
be down. Please try the request again. Your cache administrator is webmaster. Generated Mon, 17 Oct 2016 11:55:23 GMT by s_ac15 (squid/3.5.20)