Plc Error Messages
Contents |
The error codes, along with all controller events, are recorded in the Event Log. This log can be viewed in the Event Log Monitor in RMCTools. Errors allen bradley plc error codes codes that occur on a specific axis will set the corresponding Error
Micrologix 1400 Error Codes
Bit on the axis. The most recent error code that occurred on the axis will be stored in the
Rslogix 5000 Error Codes
Last Error Number status register. Error codes that do not occur on a specific axis will not set error bits on any axes. Error Code Descriptions Command Errors These errors set
Micrologix 1100 Fault Codes
the Command Error bit, if the error code occurred on a specific axis. Note: The Command Error bit is cleared when any valid command is issued. No. Name 1 Invalid command The command number itself is not supported by the axis it was issued to. Either that command number is reserved for future commands, or it is a defined command that is cip error codes not supported by this axis type. 2 Command not implemented This error indicates that the command has not been implemented in the firmware.This error should never occur in production firmware.Please report this to Delta. 3 Invalid command parameter 0 The first command parameter had an invalid value. Refer to the commands documentation for details on valid ranges for each command parameter. 4 Invalid command parameter 1 The second command parameter had an invalid value.Refer to the commands documentation for details on valid ranges for each command parameter. 5 Invalid command parameter 2 The third command parameter had an invalid value.Refer to the commands documentation for details on valid ranges for each command parameter. 6 Invalid command parameter 3 The fourth command parameter had an invalid value.Refer to the commands documentation for details on valid ranges for each command parameter. 7 Invalid command parameter 4 The fifth command parameter had an invalid value.Refer to the commands documentation for details on valid ranges for each command parameter. 8 Invalid time calculated This error occurs when the Speed At Position (36) command is issued with starting c
be down. Please try the request again. Your cache administrator is webmaster. Generated Mon, 24 Oct 2016 06:43:36 GMT by s_wx1062 (squid/3.5.20)
be down. Please try the request again. Your cache administrator is webmaster. Generated Mon, 24 Oct 2016 06:43:36 GMT by s_wx1062 (squid/3.5.20)
be down. Please try the request again. Your cache administrator is webmaster. Generated Mon, 24 Oct 2016 06:43:36 GMT by s_wx1062 (squid/3.5.20)