Error 1 Time Machine Backup
Contents |
can not post a blank message. Please type your message and try again. HT3275: Time Machine: Troubleshooting backup issues Learn about Time Machine: Troubleshooting backup issues This discussion is one time time machine backup locked TheBreen Level 1 (0 points) Q: Time Machine: Error -1
Time Machine Backup One Folder
I've been getting this message for the past day or so: "The backup disk image '[…] name.sparsebundle' could
Time Machine Backup One User
not be accessed (error -1)." Any explanations? (Time Machine Error) Mac OS X 10.6.8I seem to remember that there was an AirPort Utility update recently, but I can't remember
Time Machine Backup Only One Folder
whether there was a firmware update included in that as well. I haven't seen this error message before, so I'm not sure whether that could be the culprit.Ideas? (I'm the kind who likes to figure out what the problem actually *is* rather than just reboot everything a few times and hope for the best.)-- Tim Time Machine, Mac OS delete time machine backups X (10.6.8) Posted on Jun 11, 2013 2:04 PM I have this question too Close Q: Time Machine: Error -1 All replies Helpful answers by Bob Timmons, Bob Timmons Jun 11, 2013 2:27 PM in response to TheBreen Level 10 (105,268 points) Wireless Jun 11, 2013 2:27 PM in response to TheBreen Suggest that you start with #C17 in Time Machine -- Troubleshooting by Pondini, our resident guru.http://pondini.org/TM/Troubleshooting.html Helpful (0) Reply options Link to this post This site contains user submitted content, comments and opinions and is for informational purposes only. Apple may provide or recommend responses as a possible solution based on the information provided; every potential issue may involve several factors not detailed in the conversations captured in an electronic forum and Apple can therefore provide no guarantee as to the efficacy of any proposed solutions on the community forums. Apple disclaims any and all liability for the acts, omissions and conduct of any third parties in connection with or related to your use of the site. All postings and use of the
a Fortune 500 verification firm. Get a Professional Answer Via email, text message, or notification as you wait on schedule time machine backups our site.Ask follow up questions if you need to. 100% Satisfaction multiple time machine backups Guarantee Rate the answer you receive. Ask David Your Own Question David, Mac Support Specialist Category: Mac encrypt time machine backups Satisfied Customers: 1363 Experience: BSc H.Dip Apple Certified Professional 39216975 Type Your Mac Question Here... David is online now time machine not backing up; Error 1 Macintosh.sparsebundle Customer https://discussions.apple.com/thread/5096611?tstart=0 Question time machine not backing up; "Error 1: Macintosh.sparsebundle could not be accesssed"I am om LionThanks Submitted: 4 years ago. Category:Mac Share this conversation Expert: David replied4 years ago. Hi my name is David and I'll do my best to answer your question.This sounds like your Time Machine backup image is damaged. You can try repair it http://www.justanswer.com/mac-computers/5q7c5-time-machine-not-backing-up-error-1-macintosh-sparsebundle.html with the Disk Utility.Please see the steps in this article where it advises to repair the disk image:http://support.apple.com/kb/ht3275If you need more assistance please reply.Best regards,David. Ask Your Own Mac Question Customer: replied4 years ago. I have not replied as I had two goes at it with an interval betweenThe Utility verifies the disk but still the back up does not complete[it did once but then reverted to the problem]Mark Expert: David replied4 years ago. Hi,It might be beyond repair, and you need to erase it and start a new first time backup.First turn off Time Machine in System Preferences.Recreate the partition table in Disk Utility. Disk Utility is in /Applications/Utilities/There are two entries on the left for each disk, select the top entry of the Time Machine disk.Click the Partition tab.Change Partition Scheme from Current to One Partition.Change the name to Time Machine, and click Apply.Then open Time Machine preferences and select the disk again to make a new full backup.You lose historical data this way, but y
Error, backup disk image could not be accessed. If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to http://www.mac-forums.com/showthread.php?t=234314 register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Welcome to Mac-Forums! Join us to comment and to customize your site experience! Members have access to different forum appearance options, and many more functions. Results 1 to 10 of 10 Thread: Time Machine Error, backup disk image could time machine not be accessed. Tweet Thread Tools Show Printable Version Subscribe to this Thread… 04-02-2011,03:20 PM #1 Ttaylor394 View Profile View Forum Posts Member Since Feb 15, 2011 Location West Virginia Posts 384 Specs:13in rMBP 2014 Yosemite Time Machine Error, backup disk image could not be accessed. Not sure if this is where i should post this, but I have always got the most responses in the Switcher Hangout, time machine backup and I am still new at things so I thought here would be best. I formatted my Seagate Freeagent External 1Tb drive to Mac OS something (journaled) yesterday evening and everything that was on it is from my Dell Laptop is now gone, and it said there were approximately 996gb of 999 available. Then I plugged it into my airport base station. Started my Time Machine found the Airport Extreme under the Shared tab, found the 'Untitled' drive and selected it as the drive to use for TM. Started the original wireless back up last night about midnight and it finished the following day around noon. I have 200.06gb used on my Mac HD, according to Finder. After the original back up via TM was done the next one was due at 2pm ish today this error popped up. "Time Machine Error The backup disk image “/Volumes/Untitled-1/Taylor’s iMac.sparsebundle” could not be accessed (error -1). Latest successful backup: 4/2/11 at 1:34 PM" I have screen shots uploaded to assist the gurus of the forums. Now as I access the external drive via finder all that is on it is 2 sparsebundles. One is Name-Taylor’s iMac 1.sparsebundle Kind-Sparse Disk Image Bundle Size-181.4GB on